Touchstone Updates On Cascadura-1ST1 Well Testing

(Touchstone, 20.Jan.2020) — Touchstone Exploration Inc. provided an exploration update, highlighted by the first stage of production testing of the Cascadura-1ST1 well on the Ortoire exploration block, onshore in the Republic of Trinidad and Tobago.

The Cascadura-1ST1 production test was designed to evaluate a potential oil zone as indicated by cased hole logs. On commencement of testing, significant pressures and natural gas volumes were encountered on the clean-up flow. As a result, the company suspended testing to bring in the appropriate equipment to measure high volumes of both natural gas and liquids.

Highlights

— The initial test interval was completed on January 17, 2020 to evaluate the lowermost 162 foot pay interval between 6,056 and 6,218 feet.

— The well was opened to test on January 18, 2020 on a 4/64″ choke for a period of 97 minutes with load fluid, hydrocarbon emulsion and gas recovered at surface prior to shut-in.

— Shut-in tubing head pressure observed at surface built to 4,200 psi, which we deemed to be higher than current equipment could safely evaluate.

— The well is currently shut-in while we mobilize a three-phase separator and testing package designed to safely evaluate the high pressures and gas volumes observed upon initial completion.

“This is the best possible outcome for the initial test results from the Cascadura well, as natural gas and liquids have superior economic value under the Trinidad fiscal regime. Based on the information acquired while drilling, the thick sand we encountered in the well appeared to contain oil with some associated gas. It is now evident that it is likely a liquids rich gas structure. Given this is only the lowermost 162 feet of pay in the well, these initial results are extremely encouraging,” Touchstone President and Chief Executive Officer Paul R. Baay said.

Cascadura-1ST1 Well Testing

As previously announced, the Cascadura-1 exploration well (Touchstone 80% working interest operator, Heritage Petroleum Company Limited 20% working interest) was sidetracked (ST1) and ultimately drilled to a total depth of 6,350 feet. Cased hole wireline logs and drilling samples indicated approximately 1,037 feet of prospective hydrocarbon pay in the Cruse and Herrera formations at depths between 1,030 and 6,350 feet.

The initial production test of the Cascadura-1ST1 well has been designed to evaluate the lower 777 feet of prospective pay found in the Herrera Gr7c formation (5,516 – 6,162 feet) and the Herrera Gr7a formation (6,162 – 6,350 feet). The test is being conducted in two stages, with the first test evaluating the interval between 6,056 and 6,218 feet which is the lowermost pay interval isolated behind a 7″ liner.

This first test commenced on January 17, 2020. Surface pressure of 2,100 psi was observed immediately upon completion and built rapidly to 3,200 psi over the span of six hours. The well was shut in overnight with pressure increasing to over 3,400 psi at surface before the well was opened on a 4/64″ choke for a period of 97 minutes. During this initial cleanup period, 64 barrels of load water were recovered as well as approximately two barrels of emulsified formation fluid. These liquids were accompanied by significant gas flow which was too high to be measured with the onsite testing equipment. Flowing pressure increased to 3,900 psi during the cleanup test at which point the company suspended testing.

The well is currently shut-in while a three-phase test separator is mobilized and installed which will allow the well to be tested safely at the high pressure and gas rates observed to date. The Company expects testing to resume over the next ten days and will provide further updates when available.

Under the Trinidad petroleum tax regime, all petroleum liquids are subject to the supplemental petroleum tax (“SPT”) which, at today’s oil prices, equates to 18 percent of net petroleum revenues. Petroleum revenues derived from the sale of natural gas are not subject to the SPT.  Given that the Company presumed the initial test interval was predominantly oil bearing, the presence of high volumes of natural gas in preliminary testing is encouraging.

Coho-1

We are currently surveying the pipeline route for the previously announced Coho-1 natural gas discovery while working with local engineering firms on the design of the surface equipment required to bring the well on production. In parallel, we are drafting the required permitting documentation to construct the pipeline with the aim of bringing the well on production by June 2020. 

Further Ortoire Exploration

The company has commenced civil work on the access roads to the next two planned exploration prospects on the Ortoire exploration property.

***